Two-component transparent epoxy primer formulated with water-based epoxy resins. It can be applied to a wide variety of substrates and acts as a connective layer with a wide variety of finishes. Especially recommended as a reinforcing layer for concrete surfaces. It can be used for the protection of cement and concrete pavements when a transparent finish is required as a primer and finish coat. Suitable for industrial and decorative areas as it provides good mechanical resistance. It is compatible with a wide variety of finishes. Multi-adherent and multi-finish.
Ideal for concrete pavements, cement and other common materials, acting as an adhesive layer and finishing layer. It can be applied on a large number of substrates such as wood, metal, tiles and low porosity materials.
*In low porosity surfaces it is recommended to carry out a prior compatibility test.
Application:
Mix the two components a ration 3:1 by weight or 2.5:1 by volume. To achieve this proportion, the entire content of component B must be poured over component A.
Stir mechanically to achieve homogenization of the mixture. Once both components are mixed together dilute 30% with water. The mixture must be used within 2 hours. After that there is a significant increase in viscosity. It is not recommended to divide the products to perform partial mixes, since a wrong mix ratio can affect the final result.
New floor: Apply on a clean and dry surface, free of dust, grease and moisture. The surface must be porous. Otherwise, a superficial roughing should be carried out using a milling or shot-blasting machine.
Previously painted floor: It is advisable to remove old paint by blasting or mechanical stripping, then proceeding as if it were a new floor.
Other surfaces: The surfaces must be clean, dry, free of dust, grease and moisture. Apply thin layers of 40 microns.
Drying time: 4-6 hours
Recoating time: 24 hours
* Recoating must be done between 24 and 72 hours, maximum within 7 days.
