Grain Mold Compound is blended with a specific amount of Catalyst, then spread over the grain surface which you desire to reproduce. The Catalyst cures the Grain Mold Compound to an exact duplicate of the grain surface in a few minutes. The mold is reusable indefinitely.
Advantages:
- Permanent repair
- Flexible at low temperatures
- Good adhesion
Catalyst M870-6001, Net 0.5 oz
Compound M870-6503, Net 4oz
Directions:
Stir the product well before using. Appy on a clean and dry surface. Measure ½ ounce of the Grain Mold Compound into a cup. Puncture the end of the Catalyst tube and add 6 drops to the compound. Blend thoroughly for 30 seconds. Cast a film of compound 1/32” thick over the grain pattern you wish to duplicate. A piece of Backing Fabric or Trace Cloth may be applied to the back of the mold immediately after spreading the compound. Allow 30 minutes cure time and remove. The Grain Mold is ready for use.
