PureStrip is a high performance, water based paint & coatings remover. Easy to use, water-based paint stripper, ideal for stripping paint, varnish, graffiti, powder coating, Artex®, stains, varnish and lacquer. It has a high level of penetration enabling it to go deep into thick coatings and work from the substrate up. Softens coating, scraps off easily.
Ideal for use on wood, timber, brick, stone, fiberglass and many other substrates.
- Safe to use, water-borne, non-corrosive.
- Gel consistency suitable for floors, walls and ceilings.
- Low odor, biodegradable, non-flammable. Does not contain harmful, restricted or banned substances.
- Suitable for interior and exterior use.
Application:
Apply on an dry surface. Use direct from container, shake well before use.
Use neat without dilution.
Apply a generous, even coat, onto surface to be stripped by brush, airless spray or roller. Leave as per recommended exposure time. On multi-layered coatings a 2nd coat may be needed.
After product has penetrated the substrate (up to 24 hours) scrape off all residues, leaving surface as clean as possible.
Clean off surface thoroughly using cold water and stain-less steel scourer, and allow to dry.
Clean tools and equipment immediately after use with water
Chemical Properties:
Benzyl alcohol emulsion
Coverage:
1- 4 m2 per ltr (depends on the type and thickness of the coating)
Exposure Time:
Varnish : 5 – 30 mins
Two pack varnish : 30–60 mins
Heavy multi layered paint : 90 mins – 8 hrs.
Two pack lacquer: 30 mins-4 hrs.
Graffiti: 5—45 mins.
Powder coating : 30 mins-1hr
In case of particularly resistant coatings, leave the product on longer. Ensure the surface is well coated and covered with plastic sheet (prevents drying out).
